Pressol grease gun with pipe and hydraulic head (12 735 + 12 731)

Specification

• Filling nipple (FN), M 10 x 1 male (12 670)
• Spout, angled, G 1/8, 150 mm (12 735)
• Coupler, 4 jaws, G 1/8 (12 731)
  
  

Special notes

• Operates with greases up to NLGI grade 2 at 20°C
• Plunger with exactly fitting when using bulk grease or cartridge
• Due to the flexibility of the push rod, the plunger can be inserted into damaged cartridges or cartridges not exactly matching the standard dimensions acc. to DIN 1283
• TÜV - certified
• Pump piston, cylinder and O-ring with 6 μ fit (no dummy lubrication)
• No dummy (apparent) lubrication. Sealing system: O-ring and ball valve prevent grease compressed in the grease gun head from feeding back.
• Performance unchanged after 40.000 actuating cycles
• Separate filling and ventilation valves on grease gun head
• Grease gun head, zinc die casting Z 410
• Sure grip handling due to deep band knurls
• Safe handle on the push rod
• Slip resistant handle on grease gun lever
• Enables even under extreme backpressure, a variable lubrication pressure with steady effort applied
• Allows lubrication in difficult to reach locations because the smallest lever operation results in grease being pumped reliably to the lubrication point.
• Plunger rod clamp on end cap enables manual pressure to be applied to spring to compress bulk grease, or to force in the plunger in damaged cartridges.
• Push rod can be locked in any position - push rod does not have to be fully retracted to release the spring pressure on the grease (grease does not saponify)
• High-speed ventilation, by half a rotation of the grease gun tube